What I Found
A practical look at installing the OneWheel GTS Rally Edition rail guards, including cleaning the rails, lining up.
The OneWheel GTS Rally Edition finally got its matching rail guards, but for a lot of us, they did not show up with the board itself. Mine arrived later, which meant the board already had a few little dings before I ever had a chance to protect it properly.
The install is straightforward: clean the rails with rubbing alcohol, peel the backing off the adhesive, line each guard up carefully with the rail edges and screw holes, press it down firmly, then remove the clear protective film after both sides are installed.
What this video covers
- What Comes In The Install
- Clean The Rails First
- Line Up The First Side
- Watch The Adhesive Backing
- Press Everything Down
The short version
The install is straightforward: clean the rails with rubbing alcohol, peel the backing off the adhesive, line each guard up carefully with the rail edges and screw holes, press it down firmly, then remove the clear protective film after both sides are installed.
